15 Appendix15.4 XML configuration for 3rd party devices82 BreakerVisu 06/16 MN01210001Z-EN www.eaton.com<GROUP>0</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION></PARAM><PARAM name="REACT_CAP_E_FWD"><LENGTH>0</LENGTH><OFFSET>0</OFFSET><GROUP>0</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION></PARAM><PARAM name="APPARENT_E_FWD"><LENGTH>2</LENGTH><OFFSET>73</OFFSET><GROUP>1</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION></PARAM><PARAM name="ACTIVE_E_REV"><LENGTH>0</LENGTH><OFFSET>0</OFFSET><GROUP>0</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION></PARAM><PARAM name="REACTIVE_E_REV"><LENGTH>0</LENGTH><OFFSET>0</OFFSET><GROUP>0</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION></PARAM><PARAM name="REACT_IND_E_REV"><LENGTH>0</LENGTH><OFFSET>0</OFFSET><GROUP>0</GROUP><SFACTOR>1</SFACTOR><REPRESENTATION>3</REPRESENTATION>

Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manual

About this manual

Writing conventions

Description of device

Device models

Topology

Wiring diagram

Terminal markings

Equipment supplied

Cleaning the resistive touchscreen

Service and warranty

Device-specific hazards

Installation

Interfaces

Preparing the cables with the SUB-D plug

Power supply

Ethernet

USB device

POW/AUX (power supply for SmartWire-DT)

RS485

Mounting

Mounting the device

Operation

Inserting and removing the SD card

Appendix

Technical data

Dimensions

Alphabetical index

BreakerVisu NZM-XMC-MDISP35-MOD

BreakerVisu NZM-XMC-MDISP35-SWD

BreakerVisu NZM-XMC-MDISP70