Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manual

Also see for BreakerVisu NZM-XMC-MDISP35-MOD: Manual Instruction leaflet Instruction leaflet Instruction leaflet

2 Operator interface2.7 “Extras” screenBreakerVisu 06/16 MN01210001Z-EN www.eaton.com 35Figure 28:“Extras” screen for Modbus RTU (3.5“ variant)Table 35: Controls in “Extras” screen 1 – Networks (7“ variant)Figure 29:Existing device types (3.5“ variant)Control ActionThe Modbus-RTU Settings pane features buttonsthat you can use to configure basic communicationparameters: the number of stop bits (1 bit / 2 bitsbutton), the baud rate (9600 / 19200 / 38400 button),and the parity (no / odd / even button). The selectedvalues will be shown to the right of the correspondingbuttons.Tap the Discover Devices button to start scanningthe Modbus RTU network for connected devices.Tap the Available Device Types button to open atable listing the device types supported by theBreakerVisu program. This table will contain fourEaton device types and four configurable device typesthat can be used for 3rd party devices.NoteThe ability to use configurable device types is anoptional BreakerVisu program feature that requires alicense.Additional information ￫ Chapter 8, “Licensing”.