FCC Statement (Compliance Statement, Part 1.1)This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) this device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may causeundesired operation.WARNING (Part 15.21): Changes or modifications not expressly approved by theparty responsible for compliance could void the user’s authority to operate thisequipment.To comply with FCC’s RF exposure limits for general population/uncontrolledexposure, the antenna(s) used for this transmitter must be installed to provide aseparation distance of at least 20 cm from all persons and must not beco-located or operating in conjunction with any other antenna or transmitter.Industry Canada StatementThe term “IC” before the certification/registration number only signifi es that theIndustry Canada technical specifications were met.InterferenceThis equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and