Eaton INDGW-X2 User Manual

Also see for INDGW-X2: Manual

Accessing the Network ModuleInstalling the Network Management Module – 16••••••••If your device has an LCD, from the LCD’s menu, navigate to Identification>>>"COM card IPv4".Note the IP address of the card.Go to the section: Accessing the web interface through Network.2.4.2.1.2 With web browser through the configuration portFor example, if your device does not have an LCD, the IP address can be discovered by accessing the web interface through RNDISand browsing to Settings>Network.To access the web interface through RNDIS, see the Accessing the web interface through RNDIS section.Navigate to Contextual help>>>Settings>>>Network & Protocol>>>IPV4.Read the IPv4 settings.2.4.2.2 Your network is not equipped with a BOOTP/DHCP server2.4.2.2.1 Define from the configuration portThe IP address can be defined by accessing the web interface through RNDIS.To access web interface through RNDIS, see the Accessing the web interface through RNDIS section.Define the IP settings:Navigate to Contextual help>>>Settings>>>Network & Protocol>>>IPV4.Select Manual (Static IP).Input the following information: Address, Subnet Mask, Default GatewaySave the changes.2.4.3 Accessing the web interface through RNDISThis connection is used to access and configure the Network Module network settings locally through a RNDIS (Ethernet over USBinterface).2.4.3.1 Connecting the configuration cable1. Connect the Micro-B to USB cable to a USB connector on the host computer.2. Connect the cable to the Settings connector on the Network Module.Note: some older Devices may not be able to display the IP address even if they have an LCD. Please consult theDevice manual.