IQ 100 Series (130/140/150) MeterProgramming the IQ 100 Series Using Software65 User and Installation Manual IM02601003E-July 2010 www.eaton.comPerforming Additional Tasks with Eaton Meter Configuration SoftwareThe following sections contain instructions for other tasks you can perform using the Eaton MeterConfiguration Software.Using Connection ManagerUse Connection Manager to Add or Remove ConnectionLocations and/or Devices at Locations.1. Click Connection>Connection Manager or click on theConnect Mgr icon. You will see the screen shown onthe right.List of Locations:On the left side of the Connection Manager screen is a Listof Locations. These are the locations of one or moremeters to which you can connect. You can Add a Locationand/or a Device; Edit a Location and/or Device; or Removea Location and/or Device.• To Add a Location:a. Click on the Add button. You will see the ConnectionManager Location Editor screen. On this screen,you program the Communication settings for eachNew Location.b. Type a Name for the New Location.c. Click Serial Port or Network.d. Enter Communications Settings:Com Port: COM 1 - 99Baud Rate: 1200 - 115200Flow Control: None or HardwareData Bits: 8 (or 7)Parity: None (Even, Odd)e. To Add a Device:- Click Add Serial (to add a Serial Port ConnectedDevice) or Add Net (to add a Network Connected Device) in the Devices at Location box. Youcan add up to 255 Devices (Serial Port and/or Network connected) at one Location.NOTES:• All devices must have the same connection parameters: Baud, Parity and Flow Control.• Multiple Devices slow down polling.
