Eaton XC-CPU101 Series Instruction Leaflet

Contents

12/14 MN05003004Z-EN71AppendixCompatibilityThe functional range of the XC-CPU101 is dependant on thehardware (HW), the installed operating system (BTS) and theversion of the programming software.The following overview informs you about the functionality independence on the hardware, BTS and easySoft-CoDeSys versions:h • The compatibility for older operating systems of theXC101 is guaranteed.• Due to the modified control configuration with existingprojects, it might be necessary that the controlconfiguration may need to be re-entered.• If a project with a new control configuration is loadedonto an XC101 with an older operating system version,only the functions of the older operating system areavailable for use.Functionality Hardware version:V01 V02 V04From operating system version: easySoft-CoDeSys-Version:Basic functionality V1.2 – – F V2.2.5.+Rev. BPRG default baud rate 57.6 kBit/s Only V1.2 – – V2.3.1PRG default baud rate 38.4 kBit/s V1.3 – – V2.3.1Multiple CAN users V1.3 – – V2.3.1CAN Device V1.3 – – V2.3.1Programming via CANopen (Routing) V1.3 – – V2.3.1MMC access – V2.0 – V2.3.1Interrupt functionality – V2.0 – V2.3.1RS232 interface in Transparent mode – V2.0 – V2.3.1Peripheral direct access – V2.0 – V2.3.1CAN direct access – V2.0 – V2.3.1CAN baud rate up to 500 kBit/s – V2.0 – V2.3.1XI/OC bus expansion with XIOC-BP-EXT V1.3 – – V2.3.2Introduction of the CAN bus load “canload” V1.3 – – V2.3.2Storage of text data bank on the MMC V1.3 – – V2.3.2Storage of project information on the MMC V1.3 – – V2.3.2System events warm and cold start V1.3 – – V2.3.2Timer interrupt V1.3 – – V2.3.2Serial interface module XIOC-SER V1.3 – – V2.3.2PROFIBUS-DP M module – – V3.01 V2.3.2SUCONET K slave – – V3.02 V2.3.2Update of the MMC's operating system – – V3.03 V2.3.2PROFIBUS-DP S module – – V3.10 V2.3.2Suconet K master module – – V3.10 V2.3.2Diagnostics – – V3.10 V2.3.2Free address specification DP – – V3.10 V2.3.2