Eaton XV400 5.7" Operating Instructions Manual

Contents

7 Maintenance and service7.2 MaintenanceMICRO PANEL XV400 5.7"/8.4" 12/2014 MN04802009Z-EN www.eaton.com 597.2.3 Cleaning the infra-red touchThe infra-red frame must be cleaned regularly.The infra-red channels may be interrupted if the infra-red frame is severely contaminated. In extremecases, this may mean that the affected zones of the touch sensor cannot be touch activated.1 Clean the infra-red frame and the display with a clean, soft, damp cloth. With stubborn contamination, spray a little cleaning agent onto the damp cloth first.Cleaning withhigh-pressure cleanersDevices with a stainless steel front can be cleaned on the front with high-pressure cleaners, providedthat: the devices are mounted according to Chapter 5.4.5 Mounting a device with stainless steel front(mounting to IP69K),  50 and the ambient conditions comply with IP69K.Permissible cleaning in compliance with the test specifications of IP69K:Tab. 17 Permissible cleaning in compliance with the test specifications of IP69KInformation in cleaning instructions: The infra-red touch needs to be cleaned if the following is indicated: On the service side, the «TOUCH ERROR» LED flashes On the taskbar of the display, one of the following icons will appear:: Contaminated touch sensor: Faulty or severely contaminated touch sensor A visualization application will show an appropriate warning.CAUTIONCleaning the deviceDamage to the device due to the use of pointed or sharp objects or by liquids. Do not use any pointed or sharp objects (e.g. knife) for cleaning. Do not use any aggressive or abrasive cleaning agent or solvent. Avoid any liquid entering the device (risk of short-circuit).Property ValuesCleaning pressure Max. 80 barWater temperature Max. 75 °CDistance of lance to device surface Min. 15 cm In practice, the specifications of the high-pressure cleaners have higher tolerances. Wetherefore urgently recommend that the following information is added to the cleaning in-structions for XV400 5.7"/8.4"; MC2 5.7" with stainless steel front.Property ValuesCleaning pressure Max. 30 bar