Eaton eNMC2 User Manual

Also see for eNMC2: User guide Installation instructions

Installing the EMPServicing the EMP – 209••••••7.3.3 Cabling the first EMP to the device7.3.3.1 Available DevicesUnable to render include or excerpt-include. Could not retrieve page.Unable to render include or excerpt-include. Could not retrieve page.7.3.3.2 Connecting the EMP to the device7.3.3.2.1 Material needed:EMPRJ45 female/female connector (supplied in EMP accessories)USB to RS485 converter cable (supplied in EMP accessories)Ethernet cable (not supplied).Device7.3.3.2.2 Connection stepsSTEP 1 – Connect the Ethernet cable to the RJ45 port of the Device.STEP 2 – Connect the other end of the Ethernet cable to the RJ-45 port on the EMP (FROM DEVICE).7.3.4 Daisy chaining EMPs7.3.4.1 Material needed:First EMP connected to the device (refer to previous section)Address must be defined before the EMP power-up otherwise the changes won't be taken into account.Do not set Modbus address to 0, otherwise the EMP will not be detected.Address must be defined before EMP power-up; otherwise, the changes will not be applied.Do not set Modbus address to 0; otherwise, the EMP will not be detected.You are using an UNLICENSED copy of Scroll PDF Exporter for Confluence. Do you find Scroll PDF Exporter useful? Consider purchasing it today:https://marketplace.atlassian.com/apps/7019/scroll-pdf-exporter-for-confluence?tab=overview&hosting=datacenter