Eaton ephesus Arena Series Installation Instructions Manual

11EATON IB528001EN Installation instructionsInstallation Instructions - Arena SeriesWARNINGNEVER use any power tools on the Luminaire while the power is on. The vibration caused by power tools maydamage the Luminaire. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE ANDFAILURE.otee:N For outdoor daytime aiming when the laser dot is difficult to see, a piece of rigid tubing may be used in place of thelaser. Outside diameter of tube must be 0.8”-0.87” (ANSI NPS ½”) to fit into the Aiming Mount. Slightly smallerconduit such as ½” EMT may be used in the mount with a grommet or other shim only if the shim is evenlydistributed around the tubing to keep it correctly aligned perpendicular to the front face plates of the luminaire.WARNINGNEVER point the aiming laser at any person or animal as it can cause permanent damage to eyes. Use laser only foraiming Luminaires as directed. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO SEVERE INJURY.otee:N Turn off laser while not in use to conserve battery life. Have a spare battery charged to facilitate the aiming process.Laser Aiming InstructionsEquipment Required:●● Tape Measures or Digital Range Finder●● Paper Plates●● Spare batteries for Laser or charger if needed●● Laser or Aiming Tube●● Aiming Mount●● 1 5/16” Socket Wrench or impact driver (For hex nuts on center stud mounts, Orient aiming)●● 3/8” Hex driver (For allen bolt, Tilt aiming)●● Torque wrench/driverPROCEDURE:1. Slide the laser into the Mount, with the on/off button at the top and the laser end directed out toward the end with theU-shaped flange. The laser does not need to fit all the way in – it’s designed to interfere as it is pressed in, about halfwaydown is sufficient.otee:N It may be necessary to file off the knurled section of the laser if it doesn’t fit properly in the Mount, as shown. Thiscan be done with a metal file and won’t damage the laser.2. For each light, insert the Mount into the back of the light Luminaire between the two heat sinks near the center, asshown on the right. If necessary, gently rock the Mount back and forth until it fully seats into place.Position the Mount to either side of the gap in the fins, this will allow the fins to help hold the mount in place. If the fitis too tight, do not force the Mount to snap in – just press in gently and align it perpendicular to the face of the light. Ifthe fit is too loose and the Mount wobbles, hold it in place during aiming by pressing down. This will hold it flat againstthe fins and ensure alignment.