Eaton ephesus Arena Series Installation Instructions Manual

14EATON IB528001EN Installation instructionsInstallation Instructions - Arena SeriesAFTER FINAL AIMING1. After aiming is complete, tighten all bolts and screws including the Allen bolt on side of Luminaire and mountinghardware.Hardware Torque ValueSide Allen Bolt 20-30 ft-lbsMounting bolt/nut 35-45 ft-lbs2. Briefly turn the laser back on or re-check view through tube to verify that the luminaire aim did not shift duringtightening.3. Remove the aiming mount from the Luminaire and proceed to the next luminaire.otee:N After aiming, verify that every luminaire is securely mounted, the hardware is fully tightened down, and that all safetycables are in place.Step 5 – Finishing TouchesTo complete the installation, verify that all mounting, connection, and aiming work is finished.●● Verify all electrical connections are tight and secured. The installer is responsible for the integrity of all connections.●● Verify all bolts and screws are tightened and properly torqued.●● Straighten up all cabling. Tie down all cables neatly. For all outdoor projects, use UV rated tie wraps and wiremanagement.CARE AND MAINTENANCEAll luminaires are prepared with a powder-coated finish. The finish on exterior luminaires may weather over time, dependingon the environmental conditions at the installation site. Proper care of the luminaires will maintain their performance andappearance.Follow a regular maintenance schedule to retain optimal light output and thermal performance. Remove any dirt, leaves andother foreign debris from the luminaire housing. Wipe the optical lenses with a clean, dry, cotton cloth to remove dust andother contaminants. A non-abrasive polycarbonate cleanser may be used periodically.WARNINGDo NOT use any abrasives such as car wax, brass cleaners or other polishes or chemicals. These may scratch,remove, or damage the protective coating, allowing moisture and pollutants to come into contact with thealuminum, possibly discoloring or pitting the finish.TROUBLESHOOTINGWARNINGBefore performing any work on the luminaire, shut off the power circuit, verify the power is off with a multimeter,and wait 2 minutes before handling luminaire to avoid electrical shock. FAILURE TO FOLLOW THIS WARNING MAYLEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.Symptom Possible Cause Corrective ActionNo light output Power is off. Check if circuit power is on.Bad wire connection. Check input wiring connections.Control signal set to 0 Verify control signalFuse blows or circuit breaker trips Crossed wires or a supply wire is groundingout.Check wiring connections.Improperly sized fuse or breaker Refer to Table 5Troubleshooting Guide

/ 16

Related manuals for Eaton ephesus Arena 190