Eaton ephesus Arena Series Installation Instructions Manual

8EATON IB528001EN Installation instructionsInstallation Instructions - Arena SeriesWARNINGNEVER connect the bare or green insulation ground wire to the black (HOT) current-carrying or white (NEUTRAL)supply wire, as this could energize the metal housing and create the risk of electrical shock. FAILURE TO FOLLOWTHIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.WARNINGDo not damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any surfacehaving a sharp edge, as this may damage the wire insulation and create the risk of electrical shock. FAILURE TOFOLLOW THIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.Control WiringWARNINGAlways turn power to Luminaire OFF before performing any work on control wiring. Turn transmitters off beforeworking on main control lines. Performing any work on control connections while Luminaires are receiving the signalmay result in transient or fluttering control signals which can cause damage to the luminaire. FAILURE TO FOLLOWTHIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.Control StandardsAll control work shall conform to ANSI E1.11 – 2008 (r2013), USITT DMX512-A, Asynchronous Serial Digital Data TransmissionStandard for Controlling Lighting Equipment and Accessories. At a minimum, DMX cable shall be 1-pair (24AWG, 7x32Stranding) Twisted (minimum of 4.8 twists/foot), Shielded (minimum of 100 ohms impedance) and <25pF/ft. Capacitance.WARNINGUse caution when connecting any 24AWG wires as they are more prone to breaking. 24 AWG may be used interminal blocks. If wire will be connected with wire nut, wago connector, or other mechanical splices, use 22AWGwire.●● LANDBURST CONTROLSe: Plug in the control lines via the 3-pin XLR whips provided with the luminaire. Use the maleXLR as the DMX input and the female as the DMX output to reduce the risk of injury and poor connection. Use an RDMcontroller to set the DMX start channel(s) of the fixture.Figure 6. XLR CablesMale DMX In Female DMXOut