Eaton ephesus Arena Series Installation Instructions Manual

2EATON IB528001EN Installation instructionsInstallation Instructions - Arena Seriesotee:N Charge the provided laser battery before installation begins.Required Material Installer shall provide: For more information refer to Section:Mounting Hardware for multi-mount fixtures Step 1 - Mount the LuminairesElectrical splicing connectors Step 3 - Make Electrical ConnectionsCable ties or wire management Step 4 - Aim the LuminairesRequired Tools Installer shall provide: For more information refer to Section:Socket wrenches and/or crescent wrenchessized to fit mounting hardware ( 1 5/16” forcenter stud mounting)Step 1 - Mount the LuminaireDMX Tester/RDM Controller (for Airburst/Landburst controls)Step 3 – Electrical Connections3/8” Hex driver for side aiming bolt Step 4 – Aim the LuminaireTorque wrench rated to a minimum of 35 ft-lbs Step 4 – Aim the LuminaireTorque driver with 3/8” hex bit rated to aminimum of 35 in-lbsStep 4 – Aim the LuminaireCalibrated light meter Step 4 – Aim the LuminaireTABLE OF CONTENTSSafety Instructions .................................................................................................................................................................1Required Materials & Tools ....................................................................................................................................................2Supply Power Specifications ..................................................................................................................................................3Installation ..............................................................................................................................................................................4Step 1 – Mount the Luminaires .......................................................................................................................................4Step 2 – Label the Luminaires (If Required) ....................................................................................................................6Step 3 – Make Electrical Connections .............................................................................................................................7Step 4 – Aim the Luminaires ...........................................................................................................................................9Step 5 – Finishing Touches.............................................................................................................................................14Care and Maintenance .........................................................................................................................................................14Troubleshooting....................................................................................................................................................................14Tools Provided by Ephesus: For more information refer to Section:Aiming Laser Step 4 – Aim the LuminaireAiming Mount Step 4 – Aim the LuminaireRequired Materials & ToolsStore luminaires in a clean, dry place, protected from dirt, water, and sunlight. See table for required storage and operatingconditions:Storage Temperature Operating Temperature Humidity-40°C to +75°C (-40°F to 167°F) -40°C to +55°C (-40°F to 131°F) 5% to 95% non-condensingStorage and Operating Conditions