Eaton i-on1000EX Installation Manual

Also see for i-on1000EX: Quick user guide

Installation i-on1000EXPage 163. Press  repeatedly to selectone of the following:Backlight LEDs ON (). MENUBACKLIGHT Backlight timed ().The backlight will glow for10 seconds after the lastkeypress. The action ofthe backlight depends onthe programming of thecontrol unit.MENUBACKLIGHT 4. Leave local programmingmode and save yourchanges (see below).To Disable/Enable the Status OK LED1. Enter Local Programmingmode.MENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS OK LED 3. Press  repeatedly toselect one of thefollowing:Status OK LED ON (). MENUSTATUS OK LED Status OK LED OFF ().The green status LEDunder the navigation keywill glow for 20 secondsafter the last press (thismay be useful when thekeypad is placed inbedrooms that should becompletely dark at night).MENUSTATUS OK LED 4. Leave local programmingmode and save yourchanges.To Disable/Enable the Status FaultLED1. Enter Local Programmingmode.MENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS FLT LED 3. Press  repeatedly toselect one of thefollowing:Status Fault LED ON (). MENUSTATUS FLT LED Status Fault LED OFF().The red Fault LED underthe navigation key isMENUSTATUS FLT LED disabled, and will notglow for any fault reports.4. Leave local programmingmode and save yourchanges (see below).To Leave Local Programming Modeand Save ChangesEITHER:Press ORClose the keypad tamper.The keypad saves the changes you have made inits local memory.You can now remove 12Vdc power, if required, orleave Installer menu on the control unit.KEY-EP External Prox ReaderFigure 25 shows the outside details of the externalprox reader KEY-EP:1. LED window.2. Retaining Screw.3. Removable Fixing Plate.4. Permanently attached cable.Figure 25 External Prox Reader KEY-EPSiting the External Prox ReaderPlease refer to page 3 for general guidelines.Note: The external prox reader is fitted with alength of 2m of the appropriate cable. The cablecan be extended up to 50m by connecting anadditional length of 7/0.2 un-screened alarmcable.Opening the External Prox ReaderTo open the external prox reader (see Figure 26):1. Undo the single retaining screw.2341