Eaton i-on30R Administration And User Manual

Also see for i-on30R: Installation instructions Engineering guide

Contents

User Menu OptionsPage 39Note: If you have a proximity tag that is already allocated, you canfind out who it belongs to by using Test – Prox Tag (page 42).7. For user types that can set the system, you can assign a remotecontrol that is not already assigned to another user:To assign a remote control, press any button on the remote control,then (if you are using a partitioned system), choose one partition toassign to the remote control.If you do not want to assign a remote control, press  at the aboveprompt.Note: If you have a remote control that is already allocated, you canfind out who it belongs to by using Test – Remotes (page 42).8. For user types that can set the system, you can assign a radio HUA(Hold-Up Alarm) device:Press a button on an unallocated HUA transmitter until you see "HUAadded", or  if you do not want to assign one.Note: If you have an HUA transmitter that is already allocated, youcan find out who it belongs to by using Test – Hold Up Alarms (page42).Note: While you are registering a new HUA transmitter, the controlunit will not respond to an alarm signal from any radio HUA it hasalready learnt.9. If you are adding a Shunt Code user, press  or  followed by  toselect the shunt group to assign to the user:The * indicates the currently-selected shunt group.10. The control unit confirms that the user has been added: