Eaton i-on30R Administration And User Manual

Also see for i-on30R: Installation instructions Engineering guide

Contents

User Menu OptionsPage 58To re-program the buttons on a remote control:1. Select System Config – Remotes – Edit.The following is displayed:2. EITHER:a) Press the button on the remote control you want to re-program.Hold down the button until you see the transmit LED flash.OR (if you do not have the remote control):a) Press  at the "Press Remote Button" prompt.b) Use  or  followed by  to select the remote control youwant to re-program.c) The display lists the first button on the remote control:d) Use  or  followed by  to select the button you wish to re-program.The top line of the display shows the identity of the remote control, thebutton you pressed or selected, and the name of the owner. Forexample:3. Use  or  followed by  to choose the function for the button:Part Set (Two-way remote control only.) To set part set B/C/D (part-setting system), or to part set the partition assigned to theremote control (partitioned system). For a part-settingsystem, use  or  followed by  to select the part set.Output To operate a user-defined output. Use  or  followed by to select the output, then use  or  followed by  toselect the output mode: On – Switches the output on. Off – Switches the output off.