Eaton i-on30R Administration And User Manual

Also see for i-on30R: Installation instructions Engineering guide

Contents

User Menu OptionsPage 52clock (that is, less than the period set by Warning Time),the event will not take action until the following day.Event Days Choose the days you want the event to occur.Press  or  to scroll through each day of the week.Press  or  to specify Yes or No.Event Actions In a partitioned system, press  or  to scroll througheach partition, and  or  to select No (no action), Full(full set), Part (part set) or Unset.In a part-setting system, select one of: Full Set, Part SetB (or C or D) or Unset.Event Exceptions Choose the exceptions (set up using Add Exception)that you want to apply to the event.Press  or  to scroll through the list of programmedexceptions. Press  or  to specify Yes (the exceptionapplies to the event) or No.Warning Time Specify the period (in minutes) you want the control unitto sound the warning tone before the start of a settingevent. Enter between 1 and 30 minutes. The default is10. There is no specific warning indication for an unsetevent.The warning tone sounds at the keypads andloudspeakers allocated to the partition(s) specified inthe event.At the beginning of the warning time, the control unitactivates any outputs of type Autoset Warning.At the end of the period, the control unit stops thewarning tone, sets the affected partition(s) without anydelay and deactivates any outputs of type AutosetWarning.Warning Tone Press  or  to choose between Audible or Silent.When Silent, the control unit will NOT sound a warningtone for the event (although the warning timer will stilloperate).If a warning tone is due from more than one event at thesame time, and any of the tones is set to "Audible", thetone will be audible.