Eaton i-on40H+ Administration And User Manual

Also see for i-on Compact: User guide Administration and User Manual Quick setup guide Administration and User Manual

Setting and UnsettingPage 203. Press the appropriate ABCD key, as configured by your installer. Thekeys are normally configured as follows: A − Sets the system fully. (For a partitioned system, only thepartition the KEY-RAS is assigned to is set). B, C or D − Sets part-set B, C or D.4. You will hear a continuous exit tone (unless the system is configuredfor silent or instant setting). The system sets as described in step 6 onpage 11 (except there is no keypad display).The key you pressed remains lit red, either for a few seconds orpermanently while the system is set (depending on configuration).This indicates that setting was successful.Unsetting from a KEY-RAS radio keypad1. Enter through the entry route designated by the installer.2. Depending on how the system is configured, you may hear an entrytone. If you hear the tone, go directly to the keypad, since you willhave limited time to unset the system before it generates an alarm.2. Within the allocated time, key in your access code and press , orpresent your proximity tag.The entry tone stops and the system unsets.The ABCD keys remain lit green, either for a few seconds orpermanently while the system is unset (depending on configuration).This indicates that unsetting was successful.Using the SecureConnect™ appThe SecureConnect app allows you to monitor and control your alarmsystem over the internet from your phone or tablet. Using the app, you can: View the status of your system. Receive notifications of alarms or set/unset actions (even when theapp is not open). View camera images generated by an alarm or other event. Set and unset the system. Switch outputs on or off.Please refer to the SecureConnect documentation for details about how toinstall and use the app.