Eaton xComfort CSAP-01 Series Assembly Instructions Manual

Also see for CSAP-01/01: Instruction leaflet

1Eaton Industries (Austria) GmbH MA-xc-use01.qxd/11.2012b / 136211171Important notes on the correct use ofxComfort productsGeneral information, use:xComfort products are designed for use in privatehomes and similar, fixed electrical installationsystems. Applicable standards can be found in theCE declarations of conformity included in the moun-ting instructions supplied with each product.Installation: Installation and connection of xComfort productsmay be carried out by an authorized specialistonly (e.g. electrician). Eaton installation recommendations need to berespected, in addition to all relevant nationalinstallation and construction regulations. Appropriate fuse protection with overvoltage pro-tection in the distribution cabinet is required (coar-se protection and surge protection). Overvoltage in the system network caused byother electrical consumers (e.g. switching ofloads) is not allowed, filters need to be provided. Data transmission in the system network used(e.g. ripple control signals from the electricity sup-plier) and harmonics are not allowed, filters needto be provided. Temporary, short brightness variations of dimmedlamps are usually caused by the above-mentionedripple control signals, they are not caused by anydefect of our devices. Ambient conditions and technical data as speci-fied in our catalogues or mounting instructionsneed to be respected, especially those referringto: Degree of protection (IP20) for in-house use Degree of pollution Ambient temperature Humidity (non-condensing) Operating temperature (also taking account ofother, additional heat sources) Operating voltage and frequency Correct and allowed max. load De-rating (reduction of performance) The mains power supply needs to be disconnec-ted before doing any installation jobs. Mechanically and/or electrically damagedxComfort devices MUST NOT be installed or bro-ught into operation. They need to be replaced bynew xComfort devices. xComfort devices MUST NOT be exposed to anymechanical stress (e.g. mechanical pressure onthe devices or strain on connection wires). xComfort devices MUST NOT be changed, neitherin technical, mechanical and/or electrical terms.Exception: Shortening of connection wires. Devices must not be opened. xComfort devices must be and stay accessible forprogramming, replacement and maintenance pur-poses (i.e. NO wall-paper on distribution boxes,NO immuring etc). Torques for screw-type terminals on the deviceneed to be respected! For terminals from third-party suppliers (e.g. lustre terminals) you need torespect the manufacturers' technical data. Once the job has been done, all the installationboxes need to be closed again. All live compo-nents need to be touch-proof. Installation boxes and distributors must be flame-retardant in compliance with the respective rulesand regulations. Neutral conductor displacements in the systemnetwork used are NOT allowed and candestroy/damage the devices. Phase and neutral conductor need to be correctlyconnected. Protective earth PE needs to be provided whererequired by terminal equipment (e.g. lamp with ametal housing). After removing any xComfort actuators, the inco-ming capacitor of the actuators needs to bedischarged (risk of electric shock). Connecting the sensors and loads or consumershas to be done in accordance with the technicalsection of our catalogue or with the mountinginstructions supplied with each product. All techni-cal data and recommendations need to be respec-ted. Any connection wires not used must be touch-proof. Country-specific waste disposal and environ-mental regulations (e.g. for defective devices, bat-teries, …) need to be respected.Applications: xComfort products MUST NOT be used for safetyinstallations and safety-relevant functions, especi-ally for: Safety temperature switches and limitingequipment of heating systems Final position detection and switch-off or safetyfunctions related to the influence of theweather on shading systems (wind,rain,hail ...)GB