GE 164D2966P126 Use And Care Manual

Also see for JKP56 Series: Use and care guide Technical service guide Owner's manual Owner's manual Owner's manual

Contents

-..OW to Set Oven for CleaningQuick Reminder:1. Press the AUTO SELF CLEAN pad.2. Press the INCREASE or DECREASE paduntil the desired Clean Time appears.—If the oven is too hot and You start to set a cleancycle, the word “OFF” wfil appear in the display.Allow additional time for cooling before you tryto set the cycle.NOTE: Only one oven at a time can be self-cleaned.1. Follow the directions in the Before a CleanCycle section.(LAUTO SELFCLEANA2. After closing the door, press theAUTO SELF CLEAN pad.4 3. Press the INCREASE orDECREASE pad until the@ \ desired Clean Time is displayed.Clean Time is normally 3 hours.vYou can change the Clean Time toe any time between 2 and 4 hours,depending on the amount of soilin your oven.The self-clean cycle will automatically begin after“CLEAN” is displayed and the time for the cleancycle is set. The words “ON” and “LOCK” willappear in the display when the door automaticallylocks. It will not be possible to open the oven dooruntil the temperature drops below the locktemperature and the LOCK light goes off.-—4. When the LOCK light is off, open the door.NOTE:l The word “clean” will be displayed, the word“DOOR” will flash and oven control will signalif you set the clean cycle and forget to close theoven door.l A fan may automatically turn on and off to coolinternal parts. This is normal and the fan maycontinue to run even after the oven is turned off.1 l You can find out when the clean cycleSTOP will be finished by pressing the STOPTIME TIME pad.To Stop a Clean Cycleo1. Press the CLEAR/OFF pad. 2. When the LOCK light goes off and the ovenCLEAR temperature has cooled below the lockingOFF temperature, open the door.(contitluell ne.rt pu,qe)31