APPENDIX D: MISCELLANEOUS REVISION HISTORYG30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL D-3DTable D-5: Major changes for G30 manual version AB2 (English)Table D-6: Major changes for G30 manual version AB1 (English)--- Added Transformer Hottest-Spot temperature, Transformer Aging Factor, Transformer Loss of Life content to description,specifications, FlexLogic operands table, actual values, FlexAnalog table, Modbus memory map, IMD tables--- Updated transformer Percent Differential element (for CT Saturation), including 1-out-of-3, including in specifications,FlexLogic operands, settings, logic diagram, and added actual values--- Updated Disconnect (Breaker) Switch number from 16 to 8 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated Neutral Time Overcurrent (TOC) number from 1 to 2 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated Phase Time Overcurrent (TOC) number from 1 to 2 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated number of Phase Instantaneous Overcurrent elements in FlexLogic operands table, settings, features per producttable, Modbus memory map2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port5-49 Updated IEC 61850 section5-177 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section10-1 Added Monitoring section10-2 Added Retrieve Files sectionC- Added Command Line Interface appendixPage Description--- Updated document throughout, including numbers of elements and FlexLogic operands table--- Added EAC compliance information throughout, including logo on title page, rear panel, added specifications, added lifeexpectancy and decommissioning, added sections on Repairs, Storage, and Disposal--- Updated several figures for consistency2-17 Added UR Signal Processing section5- Updated IEC 61850 contentA- Updated FlexAnalog tablePage Description--- Updated document throughout and put into new template. Major revision.--- Updated references to digital inputs/outputs to contact inputs/outputs for consistency--- Added content for advanced IEC 61850, for example in the Settings and Actual Values chapters2-1 Updated Table 2-1 ANSI device table and single-line diagram2- Updated Order Codes and Specifications5-28 Added RS232 Baud Rate setting to Serial Ports section. Baud rate is now configurable, with two options.5-32 Added Far-End Fault Indication (FEFI) section5-182 Added Split Phase Function setting to enable and disable the function9-2 Added Software Upgrade section to the Maintenance chapter--- Moved communications appendices B through F to new UR Series Communications Guide for UR 7.3x AB1C-1 Updated product warranty from 24 months to 10 yearsPage Description
