Using the clock, timer and control lockout. GEApUionces.comCLOCKMake sure the clock is set to thecorrect time of day.To Set the ClockThe clock must be set to the correct time ofday for the automatic oven timingfunctions to work properly. Thetime of daycannot be changed during a timed bakingor self-cleaning cycle.El Touch the CLOCK pad.[] Touch the number pads.[] Touch the STARTpad.i¸!iZ ¸ K,Tc.E.ON/OFFThe timer is a minute timer only.The timer does not control ovenoperations. The maximum settingon the timer is 9 hours and 59minutes.To Set the TimerTouch the KITCHENTIMERON/OFF pad.Touch the number pads until theamount of time you want showsin the display. Forexample, to set2 hours and 45 minutes, touch 2, 4and .5 in that order. If you make amistake touch the KITCHENTIMERON/OFF pad and begin again.F-_ Touch the STARTpad.After touching the STARTpad, SETdisappears; this tells you the time iscounting down, although the display doesnot change until one minute has passed.Seconds will not be shown in the displayuntil the last minute is counting down.% When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe KITCHENTIMERON/OFF padistouched.The 6-second tone can be canceled byfollowing the steps in the Specialfeaturesof your oven control section under Tonesat the End of a Timed Cycle.To Reset the TimerIf the display is still showing the timeremaining, you may change it by touchingthe KITCHENTIMERON/OFF pad, thentouch the number pads until the time youwant appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display),recall the remaining time bytouching the KITCHENTIMERON/OFF padand then touching the number pads toenter the new time you want.To Cancel the TimerTouch the KITCHENTIMERON/OFFpad twice.o_r_L _ i¸Control LockoutYour control will allow you to lock out thetouch pads so they cannot be activatedwhen pressed.To lock/unlock the controls:El Touch the 9 and 0 pads at the sametime for 3 seconds, until the displayshows LOC ON.r21 To unlock the control, touchthe 9 and 0 pads at the same time for3 seconds, until the display showsLOCOFF.When this feature is on and the touch padsare touched, the control will beep and thedisplay will show LOCON.The control lockout mode affects alltouch pads. No touch pads will workwhen this feature is activated.The adjustment will be retained inmemory after a power failure.15