GEAppliances.comReceptacle ocketTaoJGlass coverion some modelsSOCKe__G9 BulbGlasscover(on some models)Oven Light Replacement Ion some models)WARNING: SHOCKORBURN HAZARD: Beforereplacingovenlight bulb, disconnect the electricalpower to the range at the main fuse orcircuit breaker panel. Failure to do somay result in electric shock or burn.A CAUTION: BURNHAZARD:The glosscoverand bulbshouldberemoved when cool.Touchinghotglosswithbarehands ora damp clothcancause burns.Toremove:[-il Turn the glass cover counterclockwise1/4 turn until the tubs of the glosscover clear the grooves of the socket.Wearing latex gloves may offer abetter grip.[] Using gloves or a dry cloth, removethe bulb by pulling it straight out.Toreplace:[Z] Usea new 12O/130-volt halogen bulb,not to exceed 50 watts. Replacethebulb with the same type of bulb thatwas removed. Your model will haveone of the two types shown on theleft. To determine the correctreplacement bulb, check the bulbterminals. Bulbswith 2 straight pinterminals are G6.35 bulbs. Bulbswith2 looped terminals are G9 bulbs, tDonot interchangeJ Be sure thereplacement bulb is rated 120 volts or130 volts (NOT12 volts).ii iiii iiiiiiiIUsing gloves or a dry cloth, removethe bulb from its packaging. Do nottouch the bulb with bare fingers.Oil from skin will damage the bulband shorten its life.@%Pushthe bulb straight into thereceptacle all the way.Placethe tabs of the glass cover intothe grooves of the socket. Turn theglass cover clockwise 1/4 turn.For improved lighting inside the oven,clean the glass cover frequently usinga wet cloth. This should be done whenthe oven is completely cool.[_ Reconnect electrical power to therange.Wire cover holderOven Light Replacement Ion some models)Be sure to let the light cover and bulb coolcompletely.To remove the cover: To replace the cover:Hold a hand under the cover so [Z] Place it into groove of the lightit doesn't fall when released. With receptacle. Pull wire forward tofingers of the same hand, firmly push the center of the cover until it snapsback the wire cover holder, into place.Lift off the cover.Do not remove any screws to remove the _ Connect electrical power to the range.cover.[21 Replace bulb with a 40-wattappliance bulb.33