5-30 L30 Line Current Differential System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5The GGIO5 integer configuration points are shown below:PATH: SETTINGS Ö PRODUCT SETUP ÖØ COMMUNICATIONS ÖØ IEC 61850... ÖØ GGIO5 ANALOG CONFIGURATIONThe GGIO5 logical node allows IEC 61850 client access to integer data values. This allows access to as many as 16unsigned integer value points, associated timestamps, and quality flags. The method of configuration is similar to that ofGGIO1 (binary status values). The settings allow the selection of FlexInteger™ values for each GGIO5 integer value point.It is intended that clients use GGIO5 to access generic integer values from the L30. Additional settings are provided toallow the selection of the number of integer values available in GGIO5 (1 to 16), and to assign FlexInteger™ values to theGGIO5 integer inputs. The following setting is available for all GGIO5 configuration points.• GGIO5 UINT IN 1 VALUE: This setting selects the FlexInteger™ value to drive each GGIO5 integer status value(GGIO5.ST.UIntIn1). This setting is stored as an 32-bit unsigned integer value.The report control configuration settings are shown below:PATH: SETTINGS Ö PRODUCT SETUP ÖØ COMMUNICATIONS ÖØ IEC 61850... ÖØ REPORT... Ö REPORT 1(6) CONFIGURATIONChanges to the report configuration will not take effect until the L30 is restarted.Please disconnect any IEC 61850 client connection to the L30 prior to making setting changes to the report config-uration. Disconnecting the rear Ethernet connection from the L30 will disconnect the IEC 61850 client connection. GGIO5 UINTEGER CONFIGURATIONGGIO5 UINT In 1:OffRange: Off, any FlexInteger parameterMESSAGE GGIO5 UINT In 2:OffRange: Off, any FlexInteger parameter↓MESSAGE GGIO5 UINT 1n 16:OffRange: Off, any FlexInteger parameter REPORT 1 CONFIGURATIONREPORT 1RptID:Range: up to 66 alphanumeric charactersMESSAGE REPORT 1OptFlds: 0Range: 0 to 65535 in steps of 1MESSAGE REPORT 1BufTm: 0Range: 0 to 4294967295 in steps of 1MESSAGE REPORT 1TrgOps: 0Range: 0 to 65535 in steps of 1MESSAGE REPORT 1IntgPd: 0Range: 0 to 4294967295 in steps of 1NOTE
