GE Monogram ZV30H Installation Instructions Manual

Also see for Monogram ZV30H: Owner's manual Owner's manual Installation instructions

Contents

14Installation InstructionsINSTALLATION – VENTED TO THE OUTSIDEInstalling Drip Tray1. Lift drip tray with slots and filter channel towardthe front.2. Align the tray with the hood drip tray channel andease into position.7 FINALIZE INSTALLATION• Remove any remaining protective film from thefront face of the hood.• Be sure fan and lights operate correctly. Refer tothe Owner’s Manual for operating instructions andProblem Solver.INSTALLING BAFFLE GREASEFILTERS AND DRIP TRAY6Rear channelwith grease trayFrontchannelFilterFilterFilterInstalling Baffle Grease Filters1. Remove protective film.2. Hold both filter knobs while positioning the front endof the filter in the upper (front) filter channel. Pull thefilter as far forward as possible into the channel.3. Lift the opposite end of the filter, aligning with therear (lower) filter channel.4. Push the filter into the rear channel, allowing it tosettle into the rear channel.5. Make sure filters are seated properly.5 CONNECTING ELECTRICALVerify that the power is turned off at the source.WARNING:: If the house wiring is not2-wire with a ground wire, a ground must be pro-vided by the installer. When house wiring is alu-minum, be sure to use UL-approved antioxidantcompound and aluminum-to-copper connectors.• Remove the junction box cover.• Secure the house wiring to the junction box witha strain relief (not provided).• Connect the white lead to the branch circuit whitelead.• Connect the black lead to the branch circuit blacklead.• Connect the green/yellow lead to the branchcircuit green lead or bare ground lead.• Secure all the connections with wire nuts on eachelectrical connector. Check for secure wiring con-nections.• Push the wires into the junction box and replacethe cover. Be sure the wires are not pinched.• Secure the junction box cover with the 2 originalscrews.Put the main power disconnect switch located onthe control box cover to the ON position. Test allhood functions to ensure electrical connections.See the owner’s manual for instructions to testoperations.Junction boxcoverStrain reliefHousewiringUL listedwire nutsGreen/yellowgroundwiresBlackleadsWhiteleadsDrip traychannel