GE PDS20MFW Owner's Manual And Installation Instructions

Also see for PDS20MFWCC - Profile 19.5 cu. Ft. Bottom-Freezer Refrigerator: Dimensions and installation information

4About the controls withtemperature settings. (for other models, see next page)The temperature controls are preset in the factory at 37°F for the refrigerator compartmentand 0°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to thepreset recommended settings.The temperature controls can display both the SET temperature as well as the actualtemperature in the refrigerator and freezer. The actual temperature may vary slightly fromthe SET temperature based on usage and operating environment.Setting either or both controls to OFF stops cooling in both the freezer and refrigeratorcompartments, but does not shut off electrical power to the refrigerator.To change the temperature, press and release theWARMER or COLDER pad. The SET light will comeon and the display will show the set temperature.To change the temperature, tap either theWARMER or COLDER pad until the desiredtemperature is displayed. Refrigerator temperaturescan be adjusted between 34°F and 47°F and thefreezer temperatures can be adjusted between–6°F and +8°F.Once the desired temperature has been set,the temperature display will return to the actualrefrigerator and freezer temperatures after 5seconds. Several adjustments may be required.Each time you adjust controls, allow 24 hours for therefrigerator to reach the temperature you have set.To turn the cooling system off, tap the WARMER padfor either the refrigerator or the freezer until thedisplay shows OFF. To turn the unit back on, press theCOLDER pad for either the refrigerator or freezer.The SET light will illuminate on the side youselected. Then press the COLDER pad again (on theside where the SET light is illuminated) and it willgo to the preset points of 0°F for the freezer and37°F for the refrigerator. Setting either or bothcontrols to OFF stops cooling in both the freezerand refrigerator compartments, but does not shutoff electrical power to the refrigerator.Performance Air Flow SystemChanging the TemperatureThe Performance Air Flow System is designed tomaximize temperature control in the refrigeratorand freezer compartments. This unique specialfeature consists of the Air Tower along the backwall of the refrigerator and the Air Tunnel on thebottom portion of the freezer rear wall. Placingfood in front of the louvers on these componentswill not affect performance.NOTE: The refrigerator is shipped with protective film covering the temperature controls.If this film was not removed during installation, remove it now.Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsInstallation Instructions