GE Profile PDW8200 Series Technical Service Manual

Also see for Profile PDW8200 Series: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

– 12 –Dishwasher ComponentsDoor Components• Interlock Switch Assembly• Control Module Assembly• Flapper (Active Vent)• Detergent/Rinse Module• HarnessDoor PanelTo Remove the Door Panel:1. Open the dishwasher door to the fully openposition.2. Remove 10 screws (5 screws per side) whichhold the outer panel to the door assembly. Becareful not to remove the 4 screws (2 per side)holding the escutcheon to the door assembly.3. Slowly close the door.4. Once the door is closed, remove the 2 screwsthat connect the bottom of the outer door panelto the hinge arms.5. Carefully separate the outer door panel fromthe inner door panel.To access the active vent, flapper, and doorinterlock switch, the escutcheon keypad assemblymust be removed (See Escutcheon KeypadAssembly).To Install the Door Panel:1. Open the dishwasher door a few inches.2. Lift the outer door panel up in the verticalposition and hang the outer panel over top ofthe escutcheon.3. Close the door and install the 2 screws thatconnect the bottom of the outer door panel tothe hinge arms.4. Open the dishwasher door to the fully openposition and hold the top of the outer doorpanel in place.5. Install the 10 screws (5 screws per side)which hold the outer panel to the doorassembly.Shown with escutcheon keypad assembly and doorpanel removed.Do not removethese screwsfrom eitherside.Door ScrewsDoor ScrewsFlapper(Active Vent)DetergentModuleInterlock SwitchAssemblyHarnessControl ModuleAssembly