GE Profile PDW8200 Series Technical Service Manual

Also see for Profile PDW8200 Series: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

– 25 –Water Valve and Flood SwitchThe water valve is a 120 VAC (L1) solenoid valvethat is switched on/off by the control module. Theflood switch acts as a safety switch only and doesnot control normal operation of the water valve.The flood switch opens the L1 side of the watervalve circuit.The water valve is held in place by two machinescrews.To Replace Water Valve:The water valve can be replaced with the dish-washer installed.WARNING: Disconnect power to dishwasherbefore proceeding.1. Turn off water supply to dishwasher.2. Remove toe-kick.3. Disconnect house plumbing from dishwasher.4. Remove flood switch.5. Remove the 2 machine screws holding thewater valve to the frame.6. Disconnect connector.7. Move clamp up, away from valve, and removevalve from hose.Note: To prevent leaks after installation, ensurethat hose-to-valve connection is good and thatclamp is in place.Water Valve Test1. Attempt to activate water valve using servicemode (see Service Mode). Pump out wateras necessary using service mode. If an inter-mittent failure is suspected, activate watervalve 5 times using service mode. Water valveshould stay on for 50 - 71 seconds per activa-tion and should not turn on and off during the50 - 71 second activation time.Water ValveFlood SwitchConnectorClampWater ValveShown with flood switch removed.ScrewsNONO NCOMWXDOORINTERLOCKWRPX YXFLOODSWITCHCWATER VALVE725-1200J2-2WATER VALVE ANDFLOOD SWITCHL1 voltage from J2-2