GE Profile PDW8200 Series Technical Service Manual

Also see for Profile PDW8200 Series: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

– 14 –Control ModuleTo Remove the Control Module:1. Remove the outer door panel (see DoorComponents).2. Remove the escutcheon keypad assembly(see Escutcheon Keypad Assembly).3. Unplug the connectors from the module.4. Remove the single screw that secures themodule to the right side of inner door panel.(The screw is located on the outside of theinner door panel.)5. Slide the module out.To Install the Control Manual:1. Plug connectors into control module.2. Insert the tabs on the left side of the controlmodule into the slots on the inner door panel.3. Install the single screw that secures themodule to the right side of inner door panel.4. Install the escutcheon keypad assembly (seeEscutcheon Keypad Assembly).5. Install the door panel (see DoorComponents).Detergent/Rinse ModuleThe door panel must be removed to access thedetergent/rinse module. See Door Components.The detergent/rinse module can be activated usingservice mode. See Service Mode.The detergent/rinse module automatically dis-penses both the detergent and the rinse agent atthe appropriate times. The module is activated 2times during a wash cycle.The first time the module is activated (1), the leverslides up the right-hand path of the connecting rod.This action releases the detergent cover. Whendeactivated (2), the lever returns down the left-hand path and comes to rest under the notch inthe center of the connecting rod. At the secondactivation (3), the lever lifts the connecting rod bythe notch. This action lifts the rinse dispenserplunger and releases the rinse agent. Whendeactivated, the lever returns to its original startingposition.CoverlatchPre-washsectionMainwashsectionCoverIndicatorwindow Dispenser capRinseagentadjuster1 2 3L1 Voltage from J2-6Single Screw2 TabsFactory Test Cable PortJ2-6 RY WR1200-2800DETERGENT MODULENO NCOMWXDOORINTERLOCK