– 15 –Do not removethis screw fromeither side.Stainless Steel Bowed Panel (on somemodels)To Remove the Bowed Panel:1. Open the dishwasher door to the fully open (89degrees open) position.2. Remove 8 screws (4 screws per side) whichhold the outer panel to the door assembly. Becareful not to remove the 2 screws which holdthe escutcheon to the door assembly.3. Slowly close the door.4. Once the door is closed, remove the 2 screwsthat connect the bottom of the outer panel tothe hinge arms.5. While holding the outer panel against the doorassembly, slowly open the door to about 15degrees open so the top of the outer panel is infront of the kitchen countertop. If the dish-washer is not installed, the door does not haveto be opened.6. Rotate the bottom of the outer panel out suchthat the panel is now vertical.7. Lift up on the stainless steel outer panel suchthat top corner flanges lift up over the cornercutouts in the escutcheon. Move the panelforward and over the escutcheon so that thepanel is totally separated from the door. (Seephotos of escutcheon and outer panel below.)To Install the Bowed Panel:1. Open the door to about 15 degrees open sothat the top of the outer panel is in front of thekitchen countertop. If the dishwasher is notinstalled, the door does not have to be opened.2. Lift the outer panel up in the vertical positionand hang the outer panel over top of theescutcheon. Take care to ensure that thestainless steel panel corner flanges go overand around the escutcheon corner cutouts.3. While holding the outer panel to the escutch-eon, slowly close the door.