GE Multilin B30 Bus Differential System 5-355 SETTINGS 5.2 PRODUCT SETUP5The disconnect switch configuration settings are shown below. Changes to these values will not take effect until the UR isrestarted:PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS IEC 61850 PROTOCOL XSWI CONFIGURATIONThe CLEAR XSWI1 OpCnt setting represents the disconnect switch operating counter. As disconnect switches operate byopening and closing, the XSWI operating counter status attribute (OpCnt) increments with every operation. Frequent switchoperation may result in very large OpCnt values over time. This setting allows the OpCnt to be reset to “0” for XSWI1.Since GSSE/GOOSE messages are multicast Ethernet by specification, they are not usually be forwarded by net-work routers. However, GOOSE messages may be forwarded by routers if the router has been configured for VLANfunctionality.h) WEB SERVER HTTP PROTOCOLPATH: SETTINGS PRODUCT SETUP COMMUNICATIONS WEB SERVER HTTP PROTOCOLThe B30 contains an embedded web server and is capable of transferring web pages to a web browser such as MicrosoftInternet Explorer or Mozilla Firefox. This feature is available only if the B30 has the ethernet option installed. The webpages are organized as a series of menus that can be accessed starting at the B30 “Main Menu”. Web pages are availableshowing DNP and IEC 60870-5-104 points lists, Modbus registers, event records, fault reports, etc. The web pages can beaccessed by connecting the UR and a computer to an ethernet network. The main menu will be displayed in the webbrowser on the computer simply by entering the IP address of the B30 into the “Address” box on the web browser.Do not set more than one protocol to the same TCP/UDP port number, as this results in unreliable operation ofthose protocols. XSWI CONFIGURATIONXSWI1 ST.LOC OPERANDOffRange: FlexLogic™ operandMESSAGE XSWI2 ST.LOC OPERANDOffRange: FlexLogic™ operandMESSAGE XSWI3 ST.LOC OPERANDOffRange: FlexLogic™ operand↓MESSAGE XSWI24 ST.LOC OPERANDOffRange: FlexLogic™ operandMESSAGE CLEAR XSWI1 OpCnt:NoRange: No, YesMESSAGE CLEAR XSWI2 OpCnt:NoRange: No, YesMESSAGE CLEAR XSWI3 OpCnt:NoRange: No, Yes↓MESSAGE CLEAR XSWI24 OpCnt:NoRange: No, Yes WEB SERVER HTTP PROTOCOLHTTP TCP PORTNUMBER: 80Range: 1 to 65535 in steps of 1NOTENOTE
