Consumer SupportOperating InstructionsSafety Instructions Installation Instructions Troubleshooting Tips31Oven Light Replacement (on some models)CAUTION: Before replacing your oven light bulb,disconnect the electrical power to the range at themain fuse or circuit breaker panel. Be sure to let thelight cover and bulb cool completely.The oven light bulb is covered with aremovable glass cover that is held in placewith a bail-shaped wire. Remove the ovendoor, if desired, to reach cover easily.To remove:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmly pushback the wire cover holder. Lift offthe cover.Do not remove any screws to removethe cover.Do not touch hot bulb with a wetcloth. Replace bulb with a 40-watthousehold appliance bulb.To replace cover:Place it into the groove of the lightreceptacle. Pull the wire forward to thecenter of the cover until it snaps intoplace. When in place, the wire holdsthe cover firmly. Be certain the wireis in the depression in the center ofthe cover.Connect electrical power to the range.Wire cover holder.Removable Storage Drawer (on some models)The storage drawer is a good place to storecookware and bakeware. Do not store plastics andflammable material in the drawer.The storage drawer may be removed forcleaning under the range. Clean thestorage drawer with a damp cloth orsponge. Never use harsh abrasives orscouring pads.To remove storage drawer:Pull drawer straight out until it stops.Tilt the front of the drawer up andfree of the range.To replace storage drawer:Set the stops on the back of thedrawer over the stops in the range.Slide drawer evenly and straight back,so that the rails in the range areengaged.The storage drawer may beremoved for cleaning under therange.Removable Warming Drawer (on some models)Most cleaning can be done with thedrawer in place. However, the drawer maybe removed if further cleaning is needed.Use soap and warm water to thoroughlyclean.To remove the warming drawer:Pull the drawer straight out until itstops.Press the left rail release up and pressthe right rail release down, whilepulling the drawer forward and free.To replace the warming drawer:Place the left drawer rail aroundthe inner left rail guide and slide itin slightly to hook it.Place the right drawer rail around theinner right rail guide and slide it inslightly to hook it.Slide the drawer all the way in.Before performing any adjustments,cleaning or service, disconnect the rangeelectrical power supply at the householddistribution panel by removing the fuse orswitching off the circuit breaker. Makesure the warming drawer heating elementis cool.GEAppliances.com