49-85233 21Cooktop (Cont.)CARE AND CLEANING: CooktopReplacing Burner HeadsReplace burner heads in the correct locations accordingto size.Burner CapsReplace burner caps on burner heads. Make sure eachcap fits securely and sits flat on its corresponding burnerhead.Burner cap isproperly seated.Burner cap isNOT properlyseated.Burner cap isNOT properlyseated.Cleaning The BurnersBurner CapsWash burner caps in hot, soapy water and rinse withclean water. You may scour with a plastic scouring padto remove burned-on food particles. The round caps mayalso be cleaned in your dishwasher.Burner HeadsWash the burner heads routinely, especially after badspillovers, which could clog the openings. Lift burnersoff when cool. Use hot, soapy water. Rinse with cleanwater. For more stubborn stains, use a brush with plasticbristles.NOTE: Do not use steel wool or scouring powders toclean the burner parts as these may clog the parts.Never wash burner heads in your dishwasher asdishwasher detergents will discolor your burners.The ports in the burner heads must be kept clean at alltimes for an even, unhampered flame.Clogged or dirty burner ports or electrodes will not allowthe burner to operate properly.For proper ignition, make sure the small hole in the notchthat fits over the electrode is kept open. A sewing needleor wire twist-tie works well to unclog it.After cleaning%HIRUHSXWWLQJWKHEXUQHUFDSVKHDGV RQVRPHPRGHOV DQGRYDOKHDGFDSDVVHPEO\EDFNVKDNHRXWH[FHVVwater and allow them to dry thoroughly.CAUTION Do not operate the cooktop withoutall burner parts and grates in place.Any spill on or around an electrode must be carefullycleaned. Take care to not hit an electrode with anythinghard or it could be damaged.ElectrodeTri-ring baseRQVRPHPRGHOVThe electrode of the spark igniter is exposedwhen the burner head is removed. When oneburner is turned to LITE, all the burners spark.Do not attempt to disassemble or clean aroundany burner while another burner is on. An electricshock may result, which could cause you toknock over hot cookware.orRound hole inburner head mustbe kept clear