Gaggenau BSP 221 Manual

Also see for BSP 220: Instruction manual Instruction manual

Gaggenau BSP 221 Manual Manual pdf 18 page image

18Changing the cooking time:Call up the timer menu. Use C to select the 6"Cooking time" function. Change the cooking timeusing the rotary selector. Press I to start.Clearing the cooking time:Call up the timer menu. Use C to select the 6"Cooking time" function. Clear the cooking time withŽ. Return to normal operation with '.Cancelling the entire operation:Set the function selector to 0.Note: You can also change the heating mode andtemperature during the cooking time.End of cooking timeYou can delay the cooking time end to a later time.Example: it is 14:00. The dish requires a cooking timeof 40 minutes. You want it to be ready at 15:30.Enter the cooking time and delay the cooking time enduntil 15:30. The electronics system calculates the starttime. The appliance starts automatically at 14:50 andswitches off at 15:30.Bear in mind that food which spoils easily should notbe left in the cooking compartment for too long.Delaying the cooking time endYou have set the heating mode, temperature andcooking time.1 Touch the M symbol.2 Use C to select the 5 "Cooking time end"function.3 Set the desired cooking time end using the rotaryselector.4 Press I to start.The appliance switches to standby. The heating mode,temperature, cooking time and cooking time endappear in the display. The appliance starts at thecalculated time and switches off automatically whenthe cooking time has elapsed.Note: If the 6 symbol flashes: You have not set thecooking time. Always set the cooking time first.Once the cooking time has elapsed, the applianceswitches off. The 5 symbol flashes and an audiblesignal sounds. The signal stops early if you touch the™ symbol, open the appliance door, or set thefunction selector to 0.To change the cooking time end:Call up the timer menu. Use C to select the 5"Cooking time end" function. Set the desired cookingtime end using the rotary selector. Press I to start.To terminate the whole procedure:Set the function selector to 0.'(