5-14 Garmin G500 Pilot’s Guide 190-01102-02 Rev. BForewordSec 1SystemSec 2PFDSec 3MFDSec 4HazardAvoidanceSec 5AdditionalFeaturesSec 6Annun.& AlertsSec 7SymbolsSec 8GlossaryAppendix AAppendix BIndex5.4.1 Using SafeTaxi®Any map page that displays the navigation view can also show the SafeTaxi®airport layout within the maximum configured range. The following is a list ofpages where the SafeTaxi feature can be seen:• Navigation Map Page• Weather Datalink Page• Airport Information Page• Intersection Information Page• NDB Information Page• VOR Information Page• User Waypoint Information PageDuring ground operations the aircraft’s position is displayed in reference totaxiways, runways, and airport features. When panning over the airport, featuressuch as runway holding lines and taxiways are shown.5.4.1.1 DeclutteringThe DCLTR soft key (declutter) label advances to DCLTR-1, DCLTR -2, andDCLTR-3 each time the soft key is selected for easy recognition of declutteringlevel. Selecting the DCLTR soft key removes the taxiway markings and airportfeature labels. Selecting the DCLTR-1 soft key removes VOR station ID, the VORsymbol, and intersection names if within the airport plan view. Selecting theDCLTR-2 soft key removes the airport runway layout, unless the airport in viewis part of an active route structure. Pressing the DCLTR-3 soft key cycles backto the original map detail. With Auto-Zoom enabled, the map will automaticallyzoom to 1 NM and DCLTR-0 upon landing so SafeTaxi can be viewed. Refer toMap Declutter Levels in the Navigation Map Section.5.4.1.2 Hot Spot InformationHot Spots can contain more information about the area that can be displayedwhen selected.1. While viewing the Hot Spot area on the Navigation Map page, press the smallMFD knob to activate the cursor.2. Turn the MFD knobs to move the cursor on the Hot Spot border or into the HotSpot area and then press the ENT key.
