Garmin GPS 400 Pilot's Manual And Reference

Also see for GPS 400: Instructions Pilot's guide addendum Pilot's guide addendum Pilot's guide addendum Maintenance manual

Contents

Garmin GPS 400 Pilot's Manual And Reference Manual pdf 223 page image

GPS 400 Pilot’s Guide and Reference190-00140-60 Rev. EAPPENDIX ADATA CARD USEA-1APPENDIX A: DATA CARD USEThe Jeppesen NavData Card, and the Terrain DataCard (if applicable) supplied with the GPS 400 can beinstalled or removed when the GPS 400 is on or off. If theNavData Card is not present when the unit is turned on, a‘No Jeppesen Aviation Database - Limited to user definedwaypoints’ message appears on the Database ConfirmationPage. If the NavData Card is removed during operation,a ‘Data card removed - Unit will restart in 30 seconds’warning is displayed. A counter begins to count downand, if the card is not replaced within 30 seconds, theGPS 400 automatically re-initializes. Pressing the ENTKey will manually re-initialize the unit.GNC 420Figure A-1 Data Card Slot LocationsTerrain DataCard Slot(right-hand slot)NavDataCard Slot(left-hand slot)NOTE: There are two data card slots on theface of the GPS 400 (Figure A-1). The JeppesenNavData Card should be inserted in the left-hand slot. The right-hand slot is provided forthe Terrain Data Card.To insert the NavData or Terrain Data card(Figure A-2):1) Place the card into the appropriate card slot,with the label facing to the left and the swingarm handle at the bottom front.2) Press the data card into place until it seats onthe internal connector and the front of the cardis flush with the face of the GPS 400 unit.3) If the swing arm handle is up, gently lower thehandle and push it into place—flush with theface of the GPS 400 unit.Figure A-2 Data Card Insertion/Removal Detail