6 - WPT PAGES128Creating User Waypoints5. Press ENT to accept the selected position.6. The cursor moves to “Create?”. Press ENT toadd the new waypoint to memory.7. Press the small right knob to remove theflashing cursor.To create a new user waypoint by referencing anexisting waypoint:1. With the user waypoint page displayed, pressthe small right knob to activate the cursor.2. Use the small and large right knobs toenter a name for the new waypoint and pressENT.3. Turn the large right knob to highlight the firstreference waypoint (REF WPT) field.4. Use the small and large right knobs to enterthe identifier of the reference waypoint. Thereference waypoint can be an airport, VOR,NDB, intersection or another user waypoint.Press ENT to accept the selected identifier.5. The cursor moves to the radial (RAD) field. Usethe small and large right knobs to enterthe radial from the reference waypoint to thenew user waypoint. Press ENT to accept theselected radial.6. The cursor moves to the distance (DIS) field.Use the small and large right knobs to enterthe distance from the reference waypoint to thenew user waypoint. Press ENT to accept theselected distance.7. Turn the large right knob to highlight“Create?” and press ENT.8. Press the small right knob to remove theflashing cursor.NOTE: The 400W-series units allow you to createa new user waypoint at a defined radial anddistance from your present position. To referenceyour present position, follow the steps above, butpress CLR in step #4. “P.POS” will appear in thereference waypoint (REF WPT) field to indicatethat radial and distance information will refer-ence your present position.The second reference waypoint field (REF WPT) isa temporary reference only—not a reference thatwill be stored with the user waypoint. By default,this field will display a radial from the nearestVOR. However, you can select any waypoint—byidentifier—to use as a reference in this field.Your 400W-series unit can store user-defined
