Section 4 • Repair ProceduresNovember 2014Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT 4 - 23Kubota D1105 Engine4-1Timing AdjustmentComplete information to perform this procedure isavailable in theKubota D1105 Workshop Manual (Kubota partnumber 9Y111-00123).Kubota D1105 Workshop ManualGenie part number 2297614-2Glow PlugsHow to Check the Glow Plugs1 Connect the leads from an ohmmeter betweenthe far left glow plug and ground.Result: The resistance should be approximately1Ω.2 If the ohm reading is different than 1Ω, removethe wire and connector plate from the threeindividual glow plugs. Then, one glow plug at atime, measure the resistance between the glowplug and ground.Result: The resistance should be approximately1.8Ω for each individual glow plug.3 Install the connector plate and wires to all threeglow plugs.4 Turn the key switch to ground control and pullout the red Emergency Stop button to the onposition.5 Connect the red positive (+) lead from a voltmeter to the number three glow plug. Connectthe black negative (-) lead to ground.6 Hold the glow plug switch in the on position.Result: The volt meter should read 12V DC ormore.
