Part No. 48412 Genie S-60 & Genie S-65 7 - 67Service Manual - Second Edition Section 7 - Repair Procedures2WD STEERING AXLE COMPONENTS13-3Tie RodHow to Remove the Tie Rod1 Remove the pin retaining fasteners, thenremove the pivot pin from each end of the tierod.2 Remove the tie rod.How to Perform the Toe-inAdjustmentPerform this procedure on afirm, level surface. Block thenon-steering tires and be surethat the machine is in thestowed position.1 Straighten the steer wheels.2 Measure the steer tires, front to front and backto back, using a measuring fixture.3 Center a lifting jack of ample capacity under thesteering axle, then raise the machine.4 Loosen the jam nut on the adjustable endof the tie rod.5 Remove the pin retaining fasteners, thenremove the pivot pin from the adjustable end ofthe tie rod.6 Slide the tie rod off the yoke and adjust it byturning the end.One half turn on the adjustableend equals approximately 1/ 4 inch(6.4 mm) change in the frontand rear measurements.7 Slide the tie rod onto the yoke. Install thepivot pin, then install the retaining bolt.8 Tighten the jam nut against the tie rod.9 Lower the machine and recheck thefront and back measurements (step 2).If further adjustment is needed, repeatsteps 3 through 8.Toe-in specification 0 ± 1 / 8 inch (6.35 mm)800-610-4101ActionRental.com
