September 2018 Service and Repair ManualTurntable Rotation ComponentsPart No. 1288652GT S® -60 XC ™ • S® -65 XC ™ 959 A graphic of the machine pitch will now beshown on the display. By pressing the UP orDOWN buttons, the graphic will change toshow the counterweight being uphill ordownhill. Select the image that corresponds tothe current pitch of the machine and press OK.Turntable Pitch1 uphill2 downhill10 The next calibration of the machine is themachine roll. This is the angle of the machinefrom side to side.11 Place the digital level onto the swing chassisbearing plate, which is located to the left of thefuel tank. Orient the level along the roll axis ofthe machine.12 Enter the value as seen on the digital levelonto the ground control display. If the level isshowing a negative value, enter it as a positivenumber. Press OK when the value on theground control display matches the value ofthe digital level sensor (excluding theplus/minus sign).13 A graphic of the machine roll will now beshown on the display. By pressing the UP andDOWN buttons, the graphic will change toshow whether the operator is on the uphill ordownhill side of the machine.. Select the imagethat corresponds to the current roll of themachine and press OK.Turntable Roll1 uphill2 downhill14 The calibration is now complete.15 Exit the Service Mode.
