FIC-1GEF/FIC-2GEF 151Figure 174 Ethernet cableConnecting the InterfaceCableStep 1: Connect one end of the cable to the Ethernet interface on the router andthe other end to another device.Step 2: Power on the router and check the behavior of the LINK LED on the panel.ON means a link is present and OFF means no link is present. In the latter case,check the line status.FIC-1GEF/FIC-2GEFIntroduction FIC-1GEF/FIC-2GEF, the 1-port/2-port 1000Base-SX/1000Base-LX GE fiberinterface card, is used for router-to-LAN communication.The cards support:■ Five types of 1000Base-SX/1000Base-LX SFP modules: multi-mode short-haul(850 nm), single-mode medium-haul (1310 nm), single-mode long-haul (1310nm), single mode long-haul (1550 nm), and single-mode ultra-long haul (1550nm)■ Operation at 1000 Mbps■ Full duplexInterface Attributes The following table describes the interface attributes of the FIC-1GEF/FIC-2GEF:Table 106 Interface attributes of the FIC-1GEF/FIC-2GEFAttribute FIC-1GEF FIC-2GEFConnector SFPNumber ofinterfaces1 2Interfacestandard802.3, 802.3u, 802.3abOpticaltransmitterpowerType Multi-modeshort-haul(850 nm)Single-modemedium-haul (1310nm)Long-haul(1310 nm)Long-haul(1550 nm)Ultra-long haul(1550 nm)Min. -9.5 dBm -9 dBm -2 dBm -4 dBm -4 dBmMax. 0 dBm -3 dBm 5 dBm 1 dBm 2 dBmReceiversensitivity-17 dBm -20 dBm -23 dBm -21 dBm -22 dBmCentralwavelength850 nm 1310 nm 1310 nm 1550 nm 1550 nm
