SIC-1FEF 61and the other end into the BSV interface of the SIC-1BSV/SIC-2BSV interfacecard.■ If the line is an ISDN S/T interface line, directly connect the cable to the BSVinterface of the SIC-1BSV/SIC-2BSV interface card.2 To connect the interface card to a TE device, use a crossover S/T interface cable.Connect the RJ-45 plug at one end of the cable to the BSV interface, the RJ-45receptacle to a straight-through S/T interface cable, and then the straight-throughcable to the TE device.SIC-1FEFIntroduction SIC-1FEF is short for 1-port 100 Mbps fiber Ethernet interface card, where FE isshort for Fast Ethernet and F for fiber, indicating an optical fiber interface.SIC-1FEF is used for the communication between the router and LAN.SIC-1FEF supports:■ Five types of SFP removable optical interface modules: multimode short-haul(850 nm), single-mode medium-haul (1310 nm), single-mode long-haul (1310nm), single-mode long-haul (1550 nm), and single-mode ultra-long haul (1550nm).■ 1000 Mbps interface rate■ Full duplexInterface Attributes The following table describes the interface attributes of the SIC-1FEF.Table 33 Interface attributes of SIC-1BSV/SIC-2BSVAttribute DescriptionNumber ofconnectors1Connector SFP/LCInterface standard 802.3, 802.3u, and 802.3abTransmittingopticalpowerType Multimodeshort-haul(850 nm)OpticalinterfacemoduleSingle-modemedium-haul (1310nm)OpticalinterfacemoduleLong-haul(1310 nm)OpticalinterfacemoduleLong-haul(1550 nm)OpticalinterfacemoduleUltra-longhaul (1550nm)OpticalinterfacemoduleMin. -9.5 dBm -9 dBm -2 dBm -4 dBm -4 dBmMax. 0 dBm -3 dBm 5 dBm 1 dBm 2 dBmReceiver sensitivity -17 dBm -20 dBm -23 dBm -21 dBm -22 dBmCentralwavelength850 nm 1310 nm 1310 nm 1550 nm 1550 nmFiber type 62.5/125μmmultimode9/125 μmsingle mode9/125 μmsingle mode9/125μmsingle mode9/125μmsingle modeMax. transmissionsegment0.55 km(0.34 mi.)10 km (6.21mi.)40 km (24.86mi.)40 km (24.86mi.)70 km (43.50mi.)
