FIC-1POS 191Interface LEDs The following figure illustrates the FIC-1G.SHDSL panel:Figure 233 FIC-1G.SHDSL panelThe following table describes the LEDs on the FIC-1G.SHDSL panel.Interface Cable The FIC-1G.SHDSL cards use regular telephone cables for connection.Connecting the InterfaceCableYou simply need a telephone cable to connect the RJ11 interface on anFIC-1G.SHDSL card to PSTN.FIC-1POSIntroduction FIC-1POS, the 1-port SDH/SONET interface card, supports interface rates up to155.52 Mbps (STM-1/OC-3).The FIC-1POS uses the protocols such as PPP, Frame Relay and HDLC at the datalink layer and IP at the network layer. It allows direct transmission of packets overSONET/SDH. It supports:■ Four types of SFP: multi-mode short-haul (1310 nm), single mode medium-haul(1310 nm), single mode long-haul (1310 nm), and single-mode ultra-long haul(1550 nm).■ 155.52 Mbps fractional interfaceInterface Attributes The following table describes the interface attributes of the FIC-1POS.Interface rate In single-pair mode, supports thesending/receiving independentsymmetric rates in the range from 192kbps to 2304 kbps in steps of 8 kbps.Interface cable Telephone cableSupported services G.SHDSL over telephone linesTable 135 Interface attributes of the FIC-1G.SHDSLAttribute FIC-1G.SHDSLTable 136 LEDs on the FIC-1G.SHDSL panelLED DescriptionLINK OFF means no link is present; ON means alink is present.ACT OFF means no data is being transmitted orreceived; blinking means data is beingreceived or/and transmitted.
