FIC-IMA-4T1/FIC-IMA-8T1 215Step 4: Power on the router. Check the behavior of the LINK LED for the slot onthe card panel: OFF means the line has problem and signal is out ofsynchronization. Check the link status.FIC-IMA-4T1/FIC-IMA-8T1Introduction The 4-port/8-port T1 ATM inverse multiplexing interface card(FIC-IMA-4T1/FIC-IMA-8T1) provides four/eight T1 interfaces that support the IMAtechnology. Their network application is similar to that of theFIC-IMA-4E1/FIC-IMA-8E1 card.Interface Attributes The following table describes the interface attributes of theFIC-IMA-4T1/FIC-IMA-8T1:Interface LEDs The following figures illustrate the FIC-IMA-4T1 and FIC-IMA-8T1 panels:Figure 263 FIC-IMA-4T1 panelTable 159 Interface attributes of the FIC-IMA-4T1/FIC-IMA-8T1AttributeDescriptionFIC-IMA-4T1 FIC-IMA-8T1Connector DB-68Number ofconnectors1Interface standard ITU-G.703, ITU-G.704Cable type 4T1 conversion cable(100-ohmstraight-throughshielded)8T1 conversion cable (100-ohmstraight-through shielded)Max transmissiondistance150 m (492.1 ft.)Operating mode ATM T1 independent link/IMA bundle modeSupported service AAL5Protocol PPPoA, PPPoEoA, IPoA, IPoEoATransmission rate CBR/VBR-rt/VBR-nrt/UBR
