1-10To do … Use the command … Remarkssystem-viewReset DLDP state for all theports shut down by DLDP dldp resetinterface interface-typeinterface-numberReset the DLDP state for a portshut down by DLDPdldp resetSelect either of the two.Displaying and Maintaining DLDPTo do … Use the command … RemarksDisplay the DLDP configurationof a unit or a portdisplay dldp { unit-id |interface-type interface-number } Available in any view.DLDP Configuration ExampleNetwork requirementsAs shown in Figure 1-3,z Switch A and Switch B are connected through two pairs of fibers. Both of them support DLDP. Allthe ports involved operate in mandatory full duplex mode, with their rates all being 1,000 Mbps.z Suppose the fibers between Switch A and Switch B are cross-connected. DLDP disconnects theunidirectional links after detecting them.z After the fibers are connected correctly, the ports shut down by DLDP are restored.Network diagramFigure 1-3 Network diagram for DLDP configurationSwitch AGE1/0/50 GE1/0/51Switch BGE1/0/50 GE1/0/51PCConfiguration procedure1) Configure Switch A# Configure the ports to work in mandatory full duplex mode at a rate of 1000 Mbps. system-view
