1-17For detailed output description, see the corresponding command manual.DHCP TestNetwork requirementsBoth the HWPing client and the DHCP server are H3C S5100-SI/EI series Ethernet switches. Perform aHWPing DHCP test between the two switches to test the time required for the HWPing client to obtainan IP address from the DHCP server.Network diagramFigure 1-3 Network diagram for the DHCP testConfiguration procedurez Configure DHCP Server(Switch B):Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP partof the manual.z Configure HWPing Client (Switch A):# Enable the HWPing client. system-view[Sysname] hwping-agent enable# Create a HWPing test group, setting the administrator name to administrator and test tag to DHCP.[Sysname] Hwping administrator dhcp# Configure the test type as dhcp.[Sysname-hwping-administrator-dhcp] test-type dhcp# Configure the source interface, which must be a VLAN interface. Make sure the DHCP server resideson the network connected to this interface.[Sysname-hwping-administrator-dhcp] source-interface Vlan-interface 1# Configure to make 10 probes per test.[Sysname-hwping-administrator-dhcp] count 10# Set the probe timeout time to 5 seconds.[Sysname-hwping-administrator-dhcp] timeout 5# Start the test.[Sysname-hwping-administrator-dhcp] test-enable# Display test results[Sysname-hwping-administrator-dhcp] display hwping results administrator dhcpHWPing entry(admin administrator, tag dhcp) test result:Send operation times: 10 Receive response times: 10
