H3C S5120-EI Series Command Reference Manual

Also see for S5120-EI Series: Configuration guide Installation manual Configuration guide Configuration guide Operation manual

Contents

H3C S5120-EI Series Command Reference Manual Manual pdf 157 page image

147TX power high TX power is high.TX power low TX power is low.Temp high Temperature is high.Temp low Temperature is low.Transceiver info I/O error Transceiver information read and write errorTransceiver info checksum error Transceiver information checksum errorTransceiver type and port configurationmismatch Transceiver type does not match port configuration.Transceiver type not supported by porthardware Transceiver type is not supported on the port.Examples# Display the alarm information of the pluggable transceiver plugged in interface GigabitEthernet1/0/1. (The output of this command varies with devices.) display transceiver alarm interface gigabitethernet1/0/1GigabitEthernet1/0/1 transceiver current alarm information:RX loss of signalRX power lowTable 26 Output descriptionField Descriptiontransceiver current alarm information Current alarm information of the transceiverRX loss of signal Incoming (RX) signal is lost.RX power low Incoming (RX) power level is low.display transceiver diagnosisSyntaxdisplay transceiver diagnosis { interface [ interface-type interface-number ] } [ | { begin | exclude |include } regular-expression ]ViewAny viewDefault level2: System levelParametersinterface [ interface-type interface-number ]: Displays the currently measured value of digital diagnosisparameters of the H3C customized anti-spoofing pluggable optical transceiver plugged in the specifiedinterface. interface-type interface-number represents interface type and interface number. If it is notspecified, the command displays the currently measured value of digital diagnosis parameters of H3Ccustomized anti-spoofing pluggable optical transceivers in all the interfaces.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see the Fundamentals Configuration Guide.