H3C S5130-HI Series Installation Manual

Also see for S5130-30C-HI: Configuration guide

Contents

H3C S5130-HI Series Installation Manual Manual pdf 45 page image

38Figure 53 Completing the device driver installation wizardSetting terminal parametersTo configure and manage the switch through the console port, you must run a terminal emulatorprogram, TeraTermPro or PuTTY, on your PC. You can use the emulator program to connect anetwork device, a Telnet site, or an SSH site. For more information about the terminal emulatorprograms, see the user guides for these programs.The following are the required terminal settings:• Bits per second—9,600.• Data bits—8.• Parity—None.• Stop bits—1.• Flow control—None.Powering on the switchBefore powering on the switch, verify that the following conditions are met:• The power cord is correctly connected.• The input power voltage meets the requirement of the switch.• The console cable is correctly connected.• The PC has started, and its serial port settings are consistent with the console port settings onthe switch.