53S5130-30F-HIFigure 64 S5130-30F-HI front panel(1) SFP port (2) SFP port LED(3) 10/100/1000BASE-T autosensing Ethernet port (4) 10/100/1000BASE-T autosensing Ethernet portLED(5) Management Ethernet port (6) Console port(7) Mini USB console port (8) Port LED mode switching button (MODE)(9) USB port (10) System status LED (SYS)(11) SFP+ port (12) Port mode LED(13) Expansion card status LED (SLOT) (14) Power module 2 status LED (PWR2)(15) Power module 1 status LED (PWR1) (16) SFP+ port LED(17) Management Ethernet port LEDFigure 65 S5130-30F-HI rear panel(1) Grounding screw (2) Expansion card slot(3) Fan tray slot 1 (4) Fan tray slot 2(5) Power module slot 1 (6) Power module slot 2The S5130-30F-HI switch comes with power module slot 1 empty and power module slot 2 installedwith a filler panel. You can install one or two power modules for the switch as required. In this figure,two PSR150-A1 AC power modules are installed in the power module slots. For more informationabout installing and removing a power module, see "Installing/removing a power module."The S5130-30F-HI switch comes with the two fan tray slots empty. You must install two fan trays ofthe same model for the switch. In this figure, two LSPM1FANSA fan trays are installed in the fan trayslots. For more information about installing and removing a fan tray, see "Installing/removing a fantray."The S5130-30F-HI switch comes with a filler panel in the expansion card slot. You can select anexpansion card for the switch as required. In this figure, an LSWM2SP2PM interface card is installedin the expansion card slot. For more information about installing and removing an expansion card,see "Installing/removing an expansion card."
