H3C S5130-HI Series Installation Manual

Also see for S5130-30C-HI: Configuration guide

Contents

H3C S5130-HI Series Installation Manual Manual pdf 84 page image

77LED mark Status DescriptionOff The RPS DC input is abnormal or no RPS is connected.Port mode LEDTo show more information about the switch through the port status LEDs, all S5130-HI switchesexcept the S5130-54QS-HI switch provides a port mode LED. The port mode LED indicates the typeof information that the network port LEDs are showing.Table 26 Port mode LED descriptionLED mark Status DescriptionModeSteady green The port status LEDs are showing port rates.Flashing green (1 Hz) (available only forS5130-30C-PWR-HI andS5130-54C-PWR-HI switches)The port status LEDs are showing the statusof PoE power supply on the ports.Flashing yellowThe port status LEDs indicates the IRFmember ID of the switch. For example, if theports 1 to 5 are steady green, the IRFmember ID of the switch is 5.10/100/1000BASE-T autosensing Ethernet port LEDThe switch provides a status LED for each 10/100/1000BASE-T autosensing Ethernet port. The portstatus LED and the port mode LED indicate the operating state of the 10/100/1000BASE-Tautosensing Ethernet port in conjunction.Table 27 10/100/1000BASE-T autosensing Ethernet port LED descriptionPort mode LED (Mode)status Port LED status DescriptionSteady green (rate mode)Steady greenThe port is operating at 1000 Mbps. The portLED fast flashes when the port is sending orreceiving data.Steady yellowThe port is operating at 10/100 Mbps. Theport LED fast flashes when the port issending or receiving data.Flashing yellow (3 Hz) POST has failed on the port.Off No link is present on the port.Flashing green (1 Hz) (PoE mode,available only forS5130-30C-PWR-HI andS5130-54C-PWR-HI switches)Steady green PoE power supply is normal.Flashing green (3 Hz)The device attached to the port requirespower higher than the maximum or currentlyavailable PoE output power on the port.Steady yellow The port is experiencing a PoE failure.Flashing yellow (3 Hz) POST has failed on the port.Off The port is not supplying PoE power.Flashing yellow (IRF mode) Steady greenThe port status LED indicates the IRFmember ID of the switch. For example, if theports 1 to 5 are steady green, the IRF