1-10Complete the following tasks to configure RRPP:Task RemarksCreating an RRPP Domain RequiredPerform this task on all nodes in the RRPP domain.Configuring Control VLANs RequiredPerform this task on all nodes in the RRPP domain.Configuring Protected VLANs RequiredPerform this task on all nodes in the RRPP domain.Configuring RRPP Ports RequiredPerform this task on all nodes in the RRPP domain.ConfiguringRRPP RingsConfiguring RRPP Nodes RequiredPerform this task on all nodes in the RRPP domainActivating an RRPP Domain RequiredPerform this task on all nodes in the RRPP domain.Configuring RRPP TimersOptionalPerform this task on the master node in the RRPPdomain.Configuring an RRPP Ring GroupOptionalPerform this task on the edge node andassistant-edge node in the RRPP domain.z RRPP does not have an auto election mechanism, so you must configure each node in the ringnetwork properly for RRPP to monitor and protect the ring network.z Before configuring RRPP, you need to construct a ring-shaped Ethernet topology physically.Creating an RRPP DomainWhen creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain. Alldevices in the same RRPP domain must be configured with the same domain ID.Make this configuration on devices you want to configure as nodes in the RRPP domain.Follow these steps to create an RRPP domain:To do… Use the command… RemarksEnter system view system-view —Create an RRPP domain andenter RRPP domain view rrpp domain domain-id Required
